Don't
forget you can call for a 100% Inclusive Price
instead
of using this table if you prefer. Just call
Freephone 0800 077 6467 (Mon-Fri, 8.30am-5.30pm).
Help on using this table Print Close
1. If you need a one-off Prototype, the price is shown in the first column. The minimum order for a run of display boards is 25; the price of these is shown in the second column.
2. Any quantity larger than 25 can be specifed. Please add the Cost Per Board from the third column.
3. If you need self-adhesive struts to enable the boards to stand upright, please add the Struts price multiplied by the number of boards. (Please note that struts are supplied loose, not attached to the boards.
If you also wish to calculate the carriage cost for your chosen quantity,
please use the green carriage codes. How? 
Die-cut (shaped) display boards
We can drill your boards ready for hanging or die-Cut to any finished shape. The cost of drilling boards is £0.25 + VAT per hole per board.
We can also cut your boards to any shape. There are three elements to the cost of die-cutting boards:
-
The one-off forme cost ranges from £85.00 + VAT upwards depending on the size and complexity of the shape.
-
The setup cost is £45.00 + VAT per order.
-
The running cost is:
• £0.45 + VAT per board (up to A3 size)
• £0.85 + VAT per board (A3 size to A1 size)
• £1.50 + VAT per board (larger than A1 size)
For example, the price for 25 die-cut A2 boards would be £465.65 + VAT, made up as follows:
-
£399.40 for the print of the boards
-
£45.00 die-cutting setup
-
£21.25 (ie. 25 lots of £0.85) for the die-cutting itself
The forme price is not included in the example above as this is a one-off cost – we keep the forme for posterity so that any subsequent re-orders do not incur the charge again.
Single
fold 
Double
fold (Z or roll) 
Creasing 
Perforating 
Round cornering 
Drilling